the second roller is suppose to have felt on it to make the second paper thick to contact the piece after the first roller. the guys helping turned the crank too far, and stalled the machine and smoke came out of the switch. I used it to sand the cookies for this bench. ![]() it gives you the proportion for the angle of the ends. the manual is not bad, and I think the website has videos on how to change and measure the paper. mine has 2 four inch dust collection ports. ![]() for strait line flooring I would go with finer paper. after you get it fine tuned, you can see what to use it for. and use a rubber sanding bar to clean it. regular boards go through well, but some trouble getting the dust to clear and not fall on the boards, or clog the paper. I have used it to sand cookies, that are otherwise hard to do. I put 40 or 60 on the front, and 100 or 150 on the 2nd. it can be used for minor planning if you will. I put a coarser grit on the front roller, and finer on the back. It is clunky, but once you get the hang of it, it works ok.
0 Comments
Leave a Reply. |